2003 ford windstar code p1131

You search Content Auto service manual ebook pdf 2003 ford windstar code p1131, If search results do not exist, please search by others keyword.

1999-2003 FORD WINDSTAR ELECTRICAL BATTERY DRAIN DIAGNOSIS SERVICE TIPS

4

Filed Under (Ford) by admin on 18-11-2012

equency of 42Khz. Modules that share this network on the Windstar are: PCM, ABS, ICM, FEM, REM, RKE, and NGSC. Incoming search terms: p1131 ford windstar,where is the a/c condensate line on 2003 ford focus,2002 windstar p1151 code,FORD FOCUS 2003 DRAIN CHANNELS,2003 ford windstar REM fuse location,ford windstar draw ssp 4 relay,keyless entry system water ingress causing battery drain,ssp2 relay,standard corporate protocol on a 2002 ford windstar,…

2001-2003 FORD: E-150 F-150 MIL ON WITH DTC P1131 AND/OR P1151 – 4.2L ENGINE

6

Filed Under (Ford) by admin on 31-10-2012

download ISSUE: Some 2001-2003 F-150, 2004 F-150 Heritage and 2001-2003 E-150/250 vehicles equipped with a 4.2L engine may exhibit the malfunction indicator lamp (MIL) on with diagnostic trouble codes (DTCs) P1131 and/or P1151 (system too lean bank 1 or 2). This condition may be due to leaking isolator bolts/port gaskets in the upper-to-lower intake manifold mounting area. This condition is sometimes intermittent and may not be apparent on a wa…

2003-2005 Ford Excursion 6.0L TURBOCHARGER CARBON DEPOSIT DIAGNOSTICS AND SERVICE TIPS

1

Filed Under (Ford) by admin on 21-05-2013

download ISSUE Some 2003-2007 F-Super Duty, 2003-2005 Excursions, and 2004-2008 E-350/450 vehicles equipped with a 6.0L diesel engine may exhibit any one, or a combination, of the following concerns: lack of power, white/black smoke or a surge. These concerns may or may not be accompanied by any one, or a combination, of the following diagnostic trouble codes (DTCs): P0238, P0299, P0404, P0478, P2262 and/or P2263. These concerns and/or DTCs cou…

1999-2003 Ford F-150 BODY BACK GLASS SLIDING BACK GLASS WINDNOISE/WATER LEAK – SEAL REPLACEMENT

2

Filed Under (Ford) by admin on 17-04-2015

…some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by “do-it-yourselfers”. Do not assume that a condition described affects your car or truck. Contact a Ford, Lincoln, or Mercury dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated o…

1996 Ford Windstar Valve Tappet, Hydraulic Installation

0

Filed Under (Ford) by admin on 05-12-2012

…es for ford taurus,como limpiar eclair control valve,can a iac valve get intermittent heat soak in 100 degree weather,cam a bad coolant control valve damage a transmission on 07 prius,bolt torque values for 2000 taurus,airbag code24 rcm faulted b1342 00 lincoln,99 escort 2 0 torque rocker arms,4d56 valve setting,2009 Toyota Prius p1121 hose routing,2009 santa fe purge valve install,09 acadia oil in pcv valve…

2003 Ford Escape DISASSEMBLY AND ASSEMBLY Halfshaft

7

Filed Under (Ford) by admin on 25-07-2013

…utboard CV joint and halfshaft tomake sure of correct installation.AssemblyNOTE: Make sure all components are clean andfree of foreign material.14. Use a soft-face hammer to separate the1. Lubricate the outboard CV joint with Ford Highoutboard CV joint by gently tapping it off the Temperature Constant Velocity Joint Greasehalfshaft.E43Z-19590-A or equivalent meeting Ford specification ESP-M1C207-A.15. Remove the halfshaft bearing retainer circlip…

1996-2003 TAURUS, WINDSTAR TORQUE CONVERTER CLUTCH NOT ENGAGING AND/OR DIAGNOSTIC TROUBLE CODES (DTC) P0741 OR P1744

13

Filed Under (Ford) by admin on 26-11-2012

download Torque converter clutch not engaging when commanded and/or Diagnostic Trouble Codes (DTC) P0741 or P1744 stored in memory ACTION Use a scan tool (NGS/WDS) to monitor PID’s to help determine steps to take for service. Refer to the following Diagnostic Procedure for details. SERVICE PROCEDURE The torque converter clutch may not engage if one or more of the following conditions exist: • Stuck converter regulator valve • Stuck solenoid reg…

1998 Ford Windstar Hydraulic System Bleeding

2

Filed Under (Ford) by admin on 14-09-2013

…he master cylinder. 2. Install short brake tubes in the brake master cylinder and position them so that they point back into the reservoir and the ends of the pipes are submerged in brake fluid. 3. Fill the reservoir with new Ford High Performance DOT-3 Motor Vehicle Brake Fluid C6AZ-19542-AA or DOT-3 equivalent meeting Ford specification ESA-M6C25-A. 4. Cover the reservoir with a clean shop towel.5.CAUTION: Brake fluid is harmful to painted and…

Altima And Sentra 2002-2003 Qr25De Engine Exhaust Pipe Hanger Pin And Pre-Catalyst

3

Filed Under (Nissan) by admin on 31-03-2013

…r exhaust pipe hanger pin: • the exhaust pipe hanger pin is shortened on 2002-03 altima, except those that were already repaired. This repair is just not vital on sentra vehicles. (this restore may be needed only if the pnc code is r3007.) ecm reprogramming / pre-catalyst / exhaust heat shields: • ecm reprogramming is required to stop future injury to the pre-catalyst. A particular reprogramming card is out there that accommodates ecm reprogr…

Ford Windstar 1998 Brake Shoes and Lining Removal

2

Filed Under (Ford) by admin on 02-11-2013

…brake lever from secondary rear brake shoe and lining . Set up 1. Clean brake backing plate with Rotunda Brake/Clutch/Service Vacuum 164-R3622 or equivalent. 2. Use Silicone Dielectric Compound D7AZ-19A331-A or equal assembly Ford specification ESE-M1C171-A to lubricate brake backing plate-to-brake shoe and lining contact areas. 3. Apply a light coat of Premium Long Life Grease XG1-C or equal assembly Ford specification ESA-M1C75-B, to the thread…